Create, Edit and Delete Unit Types

Create, Edit and Delete Unit Types

Data Management is are a powerful feature in Zaptic. 

It enables Zaptic Portal users to:
- Setup standardized list (example: list if areas on a site, list of product etc.)
- Establish hierarchies (example: connect the area to a list of sub-areas)
- Change a task based on a specification of a unit.
- Enable Barcode scanning

On the other hand, it empowers App Users to:
- Visit the unit content page and check relevant information and files.
- Start a flow (task or training) from that page
- Consult the latest reports submitted on that unit


    • Related Articles

    • Populating Data Management - LTS Customers

      The   section of the portal is where you can add locations as well as any other unit against which you wish to report... Each section on the Data Management page will relate to a specific activity within the campaign. Depending on the varying KPI's, ...

    • FAQ: How can I delete a Task

      How can I delete a task? YOU MUST BE A PROCEDURE COLLABORATOR TO BE ABLE TO DELETE IT 1.  Find the procedure where your task is, and click on it 2. Hover over the task that you wish to delete and click on  . 3. From there a box with options will ...

    • FAQ: How can I delete a prodecure?

      How Can I Delete a procedure? YOU MUST BE A PROCEDURE COLLABORATOR TO BE ABLE TO DELETE IT BY DELETING THE PROCEDURE YOU WILL DELETE ALL TASKS INSIDE IT. 1.  Find the procedure that you wish to delete and click on it. 2. While inside the procedure ...

    • Actions In Zaptic

      Actions within Zaptic  Zaptic has been helping users raise issues quickly and easily such as Near Misses and Hazard reports. Using the Zaptic Actions feature, users can now create an assign tasks related to these reports.  Assigning Actions against ...

    • Creating Tasks and Training

      Adding a task Create one or multiple tasks which are part of your procedure from the Tasks tab in your new procedure. For example, if you own the Safety procedure one of your tasks may be a Near Miss. In the left-hand side column on the tasks tab you ...